design.freecourseweb.com

Tolerance Stack-up Analysis of GD&T-From Beginners to Stars

Tolerance Stack-up Analysis (Linear + Geometric Tolerance Stackup).

Course participants will be trained to apply tolerance stack-up analysis techniques to a wide variety of assemblies per GD&T requirements of ASME Y14.5-2018, from the very simple to the more complex situations commonly faced in industry today.  Both plus and minus and geometrically toleranced assemblies will be examined and stack-up analysis taught and practiced on each.  Many different datum structures will be discussed and analyzed.  The concepts taught in this course are:  loop analysis (also known as circuit diagrams),  inner and outer boundaries, minimum gap, maximum wall thickness, maximum interference, minimum and maximum overall dimensions, fixed and floating fastener assembly conditions, projected tolerance zones, the logic of stack-up analysis, statistical tolerancing , and much more.

What you’ll learn

Course Content

Requirements

Course participants will be trained to apply tolerance stack-up analysis techniques to a wide variety of assemblies per GD&T requirements of ASME Y14.5-2018, from the very simple to the more complex situations commonly faced in industry today.  Both plus and minus and geometrically toleranced assemblies will be examined and stack-up analysis taught and practiced on each.  Many different datum structures will be discussed and analyzed.  The concepts taught in this course are:  loop analysis (also known as circuit diagrams),  inner and outer boundaries, minimum gap, maximum wall thickness, maximum interference, minimum and maximum overall dimensions, fixed and floating fastener assembly conditions, projected tolerance zones, the logic of stack-up analysis, statistical tolerancing , and much more.

 

Introduction

1 Introduction

 

Chapter 1 Linear Tolerance Stackup

2 Tolerance Stackup Briefing

3 Linear Tolerance Stackup

4 Case Study#1

5 Assembly Shift Tolerance Stackup

6 Case Study#2

 

Chapter 2 Geometric Tolerance Stackup

7 Geometric Tolerance Review

8 Profile Tolerance Stackup

9 Case Study#3

10 Position Tolerance Stackup

11 Case Study#4

12 Hole-Shaft Assembly Position Tolerance Stack-up

13 Case Study#5

14 Factors affecting Assembly Shift

 

Chapter 3 MMC/LMC Modifier Tolerance Stackup

15 MMC Modifier Tolerance Stackup

16 Case Study#6

17 LMC Modifier Tolerance Stackup

18 Case Study#7

 

Chapter 4 Datum and Tolerance Stackup

19 Form Tolerance of Datum Feature to Tolerance Stackup

20 Orientation Tolerance of Datum Feature to Tolerance Stackup

21 Case Study#8

22 Datum Shift Tolerance Stackup

23 SIM/SEP REQT Tolerance Stackup

24 Case Study#9

 

Chapter 5 Pattern TOP stackup

25 Projected Tolerance Zone to Tolerance Stackup

26 Pattern and Pattern as Datum

27 Case Study#10

28 Composite Tolerance Stackup

 

Chapter 6 Runout Tolerance Stackup

29 Runout Tolerance Stackup

30 Case Study#11

 

Chapter 7 Statistic Tolerance Stackup

31 Statistic Tolerance Stackup

32 Case Study#12

 

Comprehensive Case Study

33 Case Study#13

 

Final Exam

34 Final Exam